The Beebop SIP Audio Terminal is a 30-Watt Amplified network device powered by high-speed dual-core industrial grade ARM processor.
Installation
- Mount the Audio Terminal in a suitable location close to Ethernet Connection and Speaker Connections.
- Connect the audio terminal to the Ethernet Connector from an Ethernet Switch.
- Connect Power Supply to 24V DC Connection
Fig 1. Power Connector
- Connect Ethernet Cable to Powered Switch
Fig 2 – Connect to Switch
Initial Configuration
- The Speaker needs to be on the same network as the Windows PC that you will initially configure.
Start up the Zone Controller Software and then click on Search
You will be presented with all the Speaker devices on the current local network.
Fig 3. – Search Grid
- Click on the Device to open edit window and select Network.
Fig 4 – Network Configuration
Select DHCP – Yes/No
If No, then enter IP Address, Subnet Mask, Gateway Address, Preferred and Secondary DNS. Click Update Device to save configuration to Speaker. If you are asked for password, the default is 1234.
- To Configure the SIP Account select SIP Config.
Fig 5 – SIP Configuration
Enter in Server IP, SIP Port, SIP User and SIP Password (Secret). Then Update Device.
The Speaker will restart.
To check the status of the connection to the SIP Server in the Search Grid.
Fig 6 – SIP Registration
For more details see ZoneController Administrator Manual.
Front-side Port Function
1. | 10/100M network port |
2. | Left Channel signal port for external line output |
3. | Right Channel Port for external line output |
4. | Left Channel Port for external line input |
5. | Right Channel Port for external line input |
6. | Volume Gain for Line Input |
7. | Microphone In |
8. | Microphone Gain |
Back-side Port Function
Power Supply | DC 24V IN |
Block Position 1 | Left Channel + Powered |
Block Position 2 | Left Channel – Powered |
Block Position 3 | Right Channel + Powered |
Block Position 4 | Right Channel – Powered |
Block Position 5 – Positive
Block Position 6 – Negative | DC24V Output Terminal, 24V power supply. Power is enabled when RELAY circuit is closed. |
Block Position 7 – 8 | RELAY Terminal, When this port receives closed circuit signal, the device will output a s 24V / 1A DC power via DC24V Output Terminal (BP 5 – 6)_ |
Features
- 100% RFC3265 compliant
- Audio Line Output and Powered Output
- Line In and Microphone Input
- Microphone and Line In Gain Control
- The speaker startup time is less than 800ms,
- Supports MP3, WMA, WAV, G.711.
- 10 GroupCast (fixed multicast addresses)
- 10 Multicast Addresses.
- CE Approved, RoHS Approved, FCC Part 15 Subpart B Certified
- 10/100Base-TX, RJ45
- Dimensions: 295 x 195 x 155 mm